Generic Preventive Measures - Checklist
To assist States with the implementation of Article 9 and Part 3 of the Technical Annex, in 2009 the then Coordinator on Generic Preventive Measures, Colonel Jean-Christophe Le Roux of France, developed a questionnaire which serves as a checklist for States to consider when they are developing procedures, guidelines or regulations on the implementation of generic preventive measures. The checklist has been reproduced in full below. It can also be found in Protocol V document CCW/P.V/CONF/2010/6/Add.1, 11 November 2010. Essentially the checklist is a tool to facilitate the implementation of generic preventive measures. While it does not have any legal status, it is hoped that the checklist will clarify various issues, establish best practises and serve to monitor and improve the implementation of generic preventive measures at the national level.
Reducing UXO sensitivity
Reducing potential civilian casualties from ERW
(a) Has the production process been qualified?
(b) Are critical characteristics for safety and UXO rate, defined in safety assessment studies, checked during production?
(c) Have the production process quality assurance methods been validated?
(d) Is there assembly line/configuration management in place during production to record batches of munitions and parts? (e.g.: to permit investigation of defaults found during tests, training and use)?
(e) When some parts of munitions are stored during the manufacturing process, are conditions and limited durations of storage known and applied? Are the parts checked before using?
(f) Is the acceptance test procedure defined in accordance with national or international standards?
5. Utilisation - 5.1 Storage
5.2 Transportation and handling
(a) Are there provisions to task manufacturers and users to attach written safety procedures for handling (and transportation) of munitions they produce and transport?
(b) Do the means of transportation (and handling) meet the specified military requirements?
(c) Are they in accordance with international hazardous materials transportation guidelines and/or UN recommendations on the transport of dangerous goods?
6. Support - 6.1 maintenance of weapon system, munitions and packaging
6.2 In service surveillance
7. Disposal Identification
Information to other parties
8. COTS and MOTS
9. Others questions for storage related to safety
List of abbreviations
ALARP: As Low As is Reasonably Practicable
AXO: Abandoned explosive Ordnance
BIT: Built In Test
CCW: Certain Conventional Weapons
COTS: Commercial Off The Shelf
EOD: Explosive Ordnance Disposal
ERW: Explosive Remnants of War (see definition in convention on CCW)
HCP: High Contracting Party
MOTS: Modified Off The Shelf
RFID: Radio Frequency Identification Device
UXO: Unexploded Ordnance (see definition in convention on CCW)