Protocol V is one of the very few instruments that addresses the design through to the production of munitions. This is a sensitive area that is generally kept within the domain of national governments and private companies. However, improvements to the design of ammunition and applying strict controls and internationally recognised quality standards throughout the production process can contribute to reducing the rate of unexploded ordnance. This is why High Contracting Parties are urged to take action in these areas.
For a discussion on standardisation across the areas of production to in-service see "A discussion on international harmonisation of the safety and suitability for service assessment
" by Dr. Michael W. Sharp, MSIAC.
Specifically on munitions manufacturing management, the third part of the Technical Annex to Protocol V encourages High Contracting Parties to carry out the following measures:
(i) Production processes should be designed to achieve the greatest reliability of munitions.
Article 36 of Additional Protocol I to the Geneva Conventions
(ii) Production processes should be subject to certified quality control measures.
(iii) During the production of explosive ordnance, certified quality assurance standards
that are internationally recognised should be applied.
(iv) Acceptance testing should be conducted through live-fire testing over a range of
conditions or through other validated procedures.
(v) High reliability standards should be required in the course of explosive ordnance
transactions and transfers.
(b) Munitions management
In order to ensure the best possible long-term reliability of explosive ordnance, States are
encouraged to apply best practice norms and operating procedures with respect to its storage.
Under Article 36 of Additional Protocol I, States have an obligation when designing, developing or purchasing new weapons to assess the risks posed by the particular weapon and its compliance with international humanitarian law. This is in line with the direction given to States under Protocol V to ensure that the processes for the production of munitions achieves a high standard of reliability.
Article 36 states: "In the study, development, acquisition or adoption of a new weapon, means or method of warfare, a High Contracting Party is under an obligation to determine whether its employment would, in some or all circumstances, be prohibited by this Protocol or by any other rule of international law applicable to the High Contracting Party."
The ICRC has published "A Guide to the Legal Review of New Weapons, Means and Methods of Warfare: Measures to Implement Article 36 of Additional Protocol I of 1977
". International Review of the Red Cross, Volume 88 Number 864 December 2006.
Protocol V does not specifically address the issue of procurement of munitions
. For a discussion on this issue see "Report of Expert Group 8 Environmental Engineering
" CEN Workshop 10 Standardisation for Defence Procurement Expert Group 8 Environmental Engineering, April 2011
Checklist on the development of munitions
The Protocol V Generic Preventive Measures checklist addresses the development of munitions. Set out below are the questions included in the checklist in the areas of specification, concept, development, qualification work and production.
(a) Does the qualification program (testing and simulation) cover all military and technical requirements and have the data been recorded and been used to assess the UXO rate and to manage them during the conflict?
(b) Does the qualification program (testing and simulation) have sufficient statistical validity to allow a reliable evaluation of the reliability and safety of munitions in all operational environments?
(c) Is there a safety assessment report which covers all safety aspects (UXO included) for the entire lifecycle?
(d) Is there any independent office or organization to check and approve safety of munitions (e.g. fuse review board, national safety authority …)?
√Has the production process been qualified?
√ Are critical characteristics for safety and UXO rate, defined in safety assessment studies, checked during production?
√ Have the production process quality assurance methods been validated?
√ Is there assembly line/configuration management in place during production to record batches of munitions and parts? (e.g.: to permit investigation of defaults found during tests, training and use)?
√ When some parts of munitions are stored during the manufacturing process, are conditions and limited durations of storage known and applied? Are the parts checked before using?
√ Is the acceptance test procedure defined in accordance with national or international standards?